How to set up and use a compressor safely

Once you have selected your compressor, here is a quick and easy guide on how to set up and use your new compressor safely.

1. Safety

Before setting up the compressor, remember to wear appropriate PPE such as glasses, ear defenders and safety boots, and avoid wearing loose clothing which could become entangled in the compressor.

2. Unbox the compressor 

Unbox the compressor and assemble any wheels, handles and/or accessories as instructed in the manual.

3. Insert oil into the compressor

Remove the oil cap and fill with new oil through the hole until the level needed. Then tighten the oil cap.

When replacing oil always ensure that the compressor is switched off. Once you have completely evacuated the air from the tank, you can then unscrew the oil drain cap from the compression chamber. To avoid an uncontrolled leakage of oil, place a gutter underneath, and collect the oil in a container. Make sure that any used oil and condensate is disposed of in compliance with protection of environment and current legislation.

4. Power on compressor and charge the tank 

Make sure the switch is “OFF” before connecting the power cord to the grid to avoid the compressor accidentally starting. To power the compressor, pull the power button up and wait until the tank is charged, it will cut off once charged.

5. Connect the air tool hose assembly 

Plug the air tool hose assembly into the couplings on the compressor. PCL compressors are available with either Airflow or XF-Euro couplings, therefore you will need to check and match the hose assembly with the couplings.

6. Connect the relevant tool 

Plug the air tool or tyre inflator into the hose assembly.

7. Set the pressure regulator

8. Power off compressor

To switch off, the button must be pressed down.

Watch the full demonstration

Compressor Tips
WARNING! Before any intervention on the machine, disconnect the power supply from the mains and wait until the compressor has cooled completely!
	Avoid extension leads Avoid using extension leads with an air compressor, the voltage drop can cause the motor to overheat which will eventually lead to the compressor motor burning out. We recommend using a longer air hose instead.
	Consider the CFM If you do plan to run your air tool some distance away from the actual compressor, you must take into consideration that air flow lost through hoses and fittings will result in pressure drops. However, the more CFM the compressor produces, the better your tool will run, even with longer hoses and more fittings.
	Drain compressor Compressors should be drained frequently to prevent water from reducing performance. They often fill with water due to moisture content in the air, therefore the compressor has a drain screw located at the lowest part of the receiver to release it.
	Oil compressor Remember to oil your air compressor regularly so it performs correctly. (You do not need to do this with oil-less compressors).
	General cleaning Before performing any cleaning or maintenance operation completely drain the air tank. Regularly clean the machine housing with a soft cloth, preferably after each use. If the dirt does not come off used a soft cloth moistened with soapy water. Never use solvents such as petrol, alcohol, ammonia, etc, as these solvents may damage the plastic parts.
	Clean the Air filter The air filter prevents dust and dirt intake. It is necessary to clean the filter after no more than 100 hours of operation. A clogged air filter greatly reduces compressor power.